General System Configuration
Configuring SNMP
4. Under Trap Configuration, check or clear the required traps, or use the
[Enable All Traps] or [Disable All Traps] buttons to select or unselect all
supported traps.
5. Click the
[Apply Changes] button.
Figure 5-11. Configuring SNMP Trap Destinations
CLI: Configuring SNMP v1 and v2c Trap Destinations
CLI Commands Used in This Section
Command Syntax CLI Reference Page
[no] snmp-server host <server_index> <host_ip_address page 8-42
| host_name> <community-string>
[no] snmp-server trap <trap> page 8-43
show snmp-server page 8-53
5-37
To Next Page
Loading...
