HP 420 User Manual

Command Line Reference
System Clock Commands
Command Usage
When SNTP client mode is enabled using the sntp-server enable command,
the sntp-server ip command specifies the time servers from which the
access point polls for time updates. The access point will poll the time
servers in the order specified until a response is received.
Example
HP420(config)#sntp-server ip 1 10.1.0.19
HP420(config)#
Related Commands
sntp-server enable (page 8-35)
show sntp (page 8-38)
sntp-server enable
This command enables SNTP client requests for time synchronization with
NTP or SNTP time servers specified by the sntp-server ip command. Use the
no form to disable SNTP client requests.
Syntax
sntp-server enable
no sntp-server enable
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
The time acquired from time servers is used to record accurate dates and
times for log events. Without SNTP, the access point only records the time
starting from the factory default set at the last bootup (i.e., 00:14:00,
January 1, 1970).
Example
HP420(config)#sntp-server enable
HP420(config)#
8-35

HP 420 Specifications

General

Model	HP 420
Category	Wireless Access Point
Data Link Protocol	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Security Features	WPA, WPA2
Power Source	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C