HP 420 User Manual

Command Line Reference
System Clock Commands
System Clock Commands
These commands are used to configure SNTP and system clock settings on
the access point.
Command Function Mode Page
sntp-server ip Specifies one or more time servers GC 8-34
sntp-server Accepts time from the specified time servers GC 8-35
enable
sntp-server Manually sets the system date and time GC 8-36
date-time
sntp-server Sets the start and end dates for daylight savings time GC 8-36
daylight-saving
sntp-server Sets the time zone for the access point’s internal clock GC 8-37
timezone
show sntp Shows current SNTP configuration settings Exec 8-38
sntp-server ip
This command sets the IP address of the servers to which SNTP time requests
are issued. Use this command with no arguments to clear all time servers from
the current list.
Syntax
sntp-server ip <1 | 2> <ip_address>
• 1 - First time server.
• 2 - Second time server.
• ip_address - IP address of a time server (NTP or SNTP).
Default Setting
137.92.140.80
192.43.244.18
Command Mode
Global Configuration
8-34

HP 420 Specifications

General

Model	HP 420
Category	Wireless Access Point
Data Link Protocol	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Security Features	WPA, WPA2
Power Source	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C