Command Line Reference
Ethernet Interface Commands
Default Setting
Auto-negotiation
Command Mode
Interface Configuration (Ethernet)
Command Usage
If auto-negotiation is disabled, the speed and duplex mode must be
configured to match the setting of the attached device.
Example
The following example configures the Ethernet interface to 100 Mbps, half-
duplex operation.
HP420(if-ethernet)#speed-duplex 100mh
HP420(if-ethernet)#
show interface ethernet
This command displays the status for the Ethernet interface.
Syntax
show interface [ethernet]
Default Setting
Ethernet interface
Command Mode
Exec
8-91
To Next Page
Loading...
