HP 420

Wireless Security Configuration
Using the Security Wizard
1. From the Wireless Interfaces SSID Configuration window, click the [Security
Suite]
button.
2. Select wizard option 6. WPA (AES-802.1x), 7. WPA (TKIP-802.1x), or 9. WPA
(TKIP-AES-802.1x), as required.
3. Select WPA, WPA2, or WPA-WPA2 support, as required.
4. Click the
[Apply Changes] button.
5. Click the Radius Server link.
6. Configure parameters for the primary RADIUS server and, optionally, a
secondary RADIUS server. See “Web: Setting RADIUS Server Parameters”
on page 7-26 for more details.
7. Click the
[Advanced Settings] button.
8. Configure time interval periods for 802.1X reauthentication and key
refresh rates.
9. Click the
[Apply Changes] button.
To Configure WPA in Pre-shared Key Mode:
1. From the Wireless Interfaces SSID Configuration window, click the [
Security
Suite]
button.
2. Select wizard option 3. WPA-PSK (AES), 4. WPA-PSK (TKIP), or 8. WPA-PSK
(TKIP-AES), as required.
3. Select the key type, Hex or Ascii.
4. For the WPA Pre-Shared Key, enter exactly 64 hexadecimal digits or
between 8 and 63 alphanumeric characters. (Be sure that all wireless
clients use the same pre-shared key.)
5. Select WPA, WPA2, or WPA-WPA2 support, as required.
6. Click the
[Apply Changes] button.
7-17