Wireless Interface Configuration
Modifying Antenna Settings
Using the CLI to Set the Transmit Power Control Limits. The follow-
ing example shows how to set the transmit power control limits when using
an external antenna with the access point.
If using the 6.5 dBi Indoor/Outdoor Directional Diversity antenna (J8445A) in
North America with the access point set to dual (b and g) mode, the TPC
settings table for dual mode (see page 6-17) indicates the following settings
are required: 40% for the low channel, 79% for the middle channel, and 40% for
the high channel.
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless-g)#transmit-limits 40 79 40
HP420(if-wireless-g)#
6-20
To Next Page
Loading...
