HP 420 User Manual

Command Line Reference
SNMP Commands
snmp-server contact
This command sets the system contact string. Use the no form to remove the
system contact information.
Syntax
snmp-server contact <string>
no snmp-server contact
string - String that describes the system contact.
(Maximum length: 255 characters)
Default Setting
Contact
Command Mode
Global Configuration
Example
HP420(config)#snmp-server contact Paul
HP420(config)#
Related Commands
snmp-server location (page 8-46)
snmp-server enable server
This command enables SNMP management access and also enables this
device to send SNMP traps (i.e., notifications). Use the no form to disable
SNMP service and trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
Default Setting
Enabled
Command Mode
Global Configuration
8-41

HP 420 Specifications

General

Model	HP 420
Category	Wireless Access Point
Data Link Protocol	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Security Features	WPA, WPA2
Power Source	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C