HP 420

Command Line Reference
Neighbor AP Detection Commands
Command Mode
Interface Configuration (Wireless)
Example
HP420(if-wireless g)#ap-detection first-scan 30
HP420(if-wireless g)#
ap-detection instant-scan
This command starts an immediate AP detection scan on the radio interface.
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless)
Command Usage
Note that ap-detection instant-scan does not work when AP Detection is
disabled.
Example
HP420(if-wireless g)#ap-detection instant-scan
HP420(if-wireless g)#rogueAPDetect (Radio G): refreshing ap
database now
rogueApDetect Completed (Radio G) : 3 APs detected
HP420(if-wireless g)#
show ap-detection config
This command displays the current AP detection configuration.
Command Mode
Exec
8-127