HP 420 User Manual

Command Line Reference
System Management Commands
Example
HP420(config-mgmt)#user pwd david davenewpwd
HP420(config-mgmt)#
cli serial
This command configures management access through the serial console
port. Use the no form to disable management access through the console port.
Syntax
cli serial enable
no cli serial
Default Setting
Enabled
Command Mode
Management Configuration
Command Usage
The access point’s serial port and reset button cannot be disabled at the
same time. When the reset button is disabled, it is not possible to disable
the serial port using this command.
Example
HP420(config-mgmt)#no cli serial
HP420(config-mgmt)#
cli telnet
This command configures management access through a Telnet connection.
Use the no form to disable management through Telnet.
Syntax
cli telnet <enable | session session_number>
no cli telnet
• enable - Enables management access through Telnet.
• session session_number - Sets the maximum number of simulta-
neous Telnet and SSH sessions allowed.
8-17

HP 420 Specifications

General

Model	HP 420
Category	Wireless Access Point
Data Link Protocol	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Security Features	WPA, WPA2
Power Source	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C