HP 420

Command Line Reference
RADIUS Authentication
radius-authentication-server timeout
This command sets the interval between transmitting authentication requests
to the RADIUS server.
Syntax
radius-authentication-server [secondary] timeout <number_of_seconds>
• secondary - Secondary server.
• number_of_seconds - Number of seconds the access point waits for
a reply before resending a request. (Range: 1-60)
Default Setting
5
Command Mode
SSID Wireless Interface Configuration
Example
HP420(if-wireless-g-ssid-1)#radius-authentication-server
timeout 10
HP420(if-wireless-g-ssid-1)#
radius-authentication-server mac-format
This command sets the format for specifying MAC addresses on the RADIUS
server.
Syntax
radius-authentication-server mac-format <multi-colon | multi-dash | no-delimiter
| single-dash>
• multi-colon - Enter MAC addresses in the form xx:xx:xx:xx:xx:xx.
• multi-dash - Enter MAC addresses in the form xx-xx-xx-xx-xx-xx.
• no-delimiter - Enter MAC addresses in the form xxxxxxxxxxxx.
• single-dash - Enter MAC addresses in the form xxxxxx-xxxxxx.
Default Setting
No delimiter
Command Mode
SSID Wireless Interface Configuration
8-64