HP 420 - ap-detection interval; ap-detection first-scan

Command Line Reference
Neighbor AP Detection Commands
• A long scan duration time will detect more access points in the area,
but causes more disruption to client access.
Example
HP420(if-wireless g)#ap-detection duration 200
HP420(if-wireless g)#
ap-detection interval
This command sets the time between each AP detection scan.
Syntax
ap-detection interval <minutes>
minutes - The time between each AP detection scan.
(Range: 15 -10080 minutes)
Default Setting
720 minutes
Command Mode
Interface Configuration (Wireless)
Example
HP420(if-wireless g)#ap-detection interval 120
HP420(if-wireless g)#
ap-detection first-scan
This command sets the time delay from enabling AP detection or a reboot
before scanning starts.
Syntax
ap-detection first-scan <minutes>
minutes - The time between each AP detection scan.
(Range: 0 -10080 minutes)
Default Setting
0 minutes
8-126