HP 420 - CLI: Setting Logging Parameters

General System Configuration
Enabling System Logging
Figure 5-12. Setting Logging Parameters
CLI: Setting Logging Parameters
CLI Commands Used in This Section
Command Syntax CLI Reference Page
[no] logging on page 8-28
[no] logging host <1 | 2 | 3 | 4> <host_name | host_ip_address> page 8-29
[udp_port]
[no] logging console page 8-29
logging level <Emergency | Alert | Critical | Error | Warning | page 8-30
Notice | Informational | Debug>
logging facility-type <type> page 8-31
show logging page 8-32
show event-log page 8-32
5-42