HP 420

Command Line Reference
System Management Commands
Example
HP420(config-mgmt)#ssh enable
HP420(config-mgmt)#
ssh port
This command sets the Secure Shell server port.
Syntax
ssh port <port-number>
port-number - The TCP port used by the SSH server. (Range: 1-65535)
Default Setting
22
Command Mode
Management Configuration
Example
HP420(config-mgmt)#ssh port 1124
HP420(config-mgmt)#
snmpv3
This command enables management access for SNMPv3 and SNMP v1/v2
clients. Use the no form to disable access for SNMPv3 or SNMP v1/v2 clients
Syntax
snmpv3 <enable | only>
no snmpv3 <enable | only>
• enable - Enables access for SNMPv3 clients.
• only - Allows access for SNMPv3 clients only. Access for SNMP v1
and v2c clients is disabled.
Default Setting
Enabled
8-19