Command Line Reference
System Management Commands
Command Usage
To avoid using common reserved TCP port numbers below 1024, the
configurable range is restricted to between 1024 and 65535. However, the
default port number is 80. To reset the default port number, use the no ip
http port command.
Example
HP420(config-mgmt)#http port 49153
HP420(config-mgmt)#
Related Commands
http server (page 8-22)
http server
This command allows this device to be monitored or configured from a
browser. Use the no form to disable this function.
Syntax
http server
no http server
Default Setting
Enabled
Command Mode
Management Configuration
Example
HP420(config-mgmt)#http server
HP420(config-mgmt)#
Related Commands
http port (page 8-21)
8-22
To Next Page
Loading...
