HP 420

Command Line Reference
General Commands
end
This command returns to the previous configuration mode.
Default Setting
None
Command Mode
Global Configuration, Interface Configuration
Example
This example shows how to return to the Configuration mode from the
Ethernet Interface Configuration mode:
HP420(if-ethernet)#end
HP420(config)#
exit
This command returns to the Exec mode or exits the configuration program.
Default Setting
None
Command Mode
Any
Example
This example shows how to return to the Exec mode from the Interface
Configuration mode, and then quit the CLI session:
HP420(if-ethernet)#exit
HP420#exit
CLI session with the Access Point is now closed
Username:
8-5