HP 420

Command Line Reference
SNMP Commands
SNMP Commands
The access point includes an agent that supports Simple Network Manage-
ment Protocol (SNMP) versions 1, 2c, and 3. Access to the agent using SNMP
v1 and v2c is controlled by community strings. To communicate with the
access point, a management station must first submit a valid community string
for authentication.
Access to the access point using SNMP v3 provides additional security
features that cover message integrity, authentication, and encryption; as well
as controlling notifications that are sent to specified user targets.
Command Function Mode Page
snmp-server Sets up the community access string to permit access GC 8-40
community to SNMP commands
snmp-server Sets the system contact string GC 8-41
contact
snmp-server Enables SNMP service and traps GC 8-41
enable server
snmp-server host Specifies the recipient of an SNMP notification GC 8-42
operation
snmp-server trap Enables specific SNMP notifications GC 8-43
snmp-server Sets the system location string GC 8-46
location
snmpv3 engine id Sets the engine ID for SNMP v3 GC 8-46
snmpv3 user Sets the name of the SNMP v3 user GC 8-47
snmpv3 targets Configures SNMP v3 notification targets GC 8-49
snmpv3 filter Configures SNMP v3 notification filters GC 8-50
snmpv3 filter- Assigns SNMP v3 notification filters to targets GC 8-51
assignments
show snmpv3 Displays SNMP v3 user settings, targets, filters, and Exec 8-52
filter assignments
show snmp-server Displays the status of SNMP communications Exec 8-53
8-39