HP 420

Command Line Reference
System Management Commands
Command Mode
Global Configuration
Example
HP420(config)#prompt RD2
RD2(config)#
system name
This command specifies or modifies the system name for this device.
Syntax
system name <name>
name - The name of this host. (Maximum length: 32 characters)
Default Setting
Enterprise AP
Command Mode
Global Configuration
Example
HP420(config)#system name HP420 Access Point
HP420(config)#
management
This command enters Management Configuration mode. You must enter this
mode to modify management access settings.
Default Setting
None
Command Mode
Global Configuration
8-13