HP 420

Command Line Reference
Wireless Interface Commands
----------------Radius Authentication Server-----------------------------
Radius Primary Server Information
IP : 0.0.0.0
Port : 1812
Key : *****
Retransmit : 3
Timeout : 5
Radius MAC Address Format : NO_DELIMITER
Radius VLAN ID Format : HEX
Radius Secondary Server Information
IP : 0.0.0.0
Port : 1812
Key : *****
Retransmit : 3
Timeout : 5
Radius MAC Address Format : NO_DELIMITER
Radius VLAN ID Format : HEX
----------------Authentication Information-------------------------------
802.1x : DISABLED
Broadcast Key Refresh Rate : 0 min
Session Key Refresh Rate : 0 min
802.1x Session Timeout Value : 0 secs
MAC Authentication Server : DISABLED
MAC Auth Session Timeout Value : 0 sec
=========================================================================
HP420#
show ssid-list
This command shows the current SSID interfaces configured on the access
point.
Command Mode
Exec
Example
HP420#show ssid-list
Total SSID created: 1
Index ssid vlan-id status primary
=================================================================
hp420 2(T) enabled yes
HP420#
8-113
1