File Transfers
Upgrade Procedure for v2.1.x Software
2. After a successful download, the prompt “Do you want to use NEW CONFIG
SETTINGS? <y/n> [n]:” appears. Type “n” to retain the current access point
configuration. (Typing “y” restores factory default settings and reboots
the access point.)
3. Reboot the access point.
HP420#reset board
Reboot system now? <y/n>: y
4. Download the upgrade boot code file, bootrom306.bin.
HP420#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:3
TFTP Source file name:bootrom306.bin
TFTP Server IP:192.168.1.10
Updating Boot code v03.00.06 NOW!
HP420#
5. Download the upgrade default software file, dflt-img.bin.
HP420#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:1
TFTP Source file name:dflt-img.bin
TFTP Server IP:192.168.1.10
Firmware version of system is v2.0.40-temp and Updating Run-
Time code v02.01.00 NOW!
Creating file! Please wait a few minutes!
Warning! Updating firmware may cause configuration settings
to be incompatible.
(Suggestion:Using new default configuration settings lets
system be more efficient,but system will lose current
settings.)
Do you want to reset to FACTORY DEFAULT SETTINGS? <y/n>
[n]:n
HP420#
A-12
To Next Page
Loading...
