12
Field Description
Internet protocol processing: Disabled
The interface is not assigned an IP address and cannot process
IP packets.
Internet address
IP address of the interface. The
primary
attribute indicates that
the address is the primary IP address.
IP packet frame type IPv4 packet framing format.
hardware address MAC address of the interface.
IPv6 packet frame type IPv6 packet framing format.
Port priority Port priority of the interface.
Loopback is set internal
An internal loopback test is running on the interface. This field
depends on your configuration .
Loopback is set external
An external loopback test is running on the interface. This field
depends on your configuration.
Loopback is not set
No loopback test is running on the interface. This field depends
on your configuration.
10Mbps-speed mode
The interface is operating at 10 Mbps. This field depends on your
configuration and the link parameter negotiation result.
100Mbps-speed mode
The interface is operating at 100 Mbps. This field depends on
your configuration and the link parameter negotiation result.
1000Mbps-speed mode
The interface is operating at 1000 Mbps. This field depends on
your configuration and the link parameter negotiation result.
10Gbps-speed mode
The interface is operating at 10 Gbps. This field depends on your
configuration and the link parameter negotiation result.
Unknown-speed mode
The speed of the interface is unknown because the speed
negotiation fails or the interface is physically disconnected.
half-duplex mode
The interface is operating in half duplex mode. This field depends
on your configuration and the link parameter negotiation result.
full-duplex mode
The interface is operating in full duplex mode. This field depends
on your configuration and the link parameter negotiation result.
unknown-duplex mode
The duplex mode of the interface is unknown because the duplex
mode negotiation fails or the interface is physically disconnected.
Link speed type is autonegotiation
The interface is configured with the
speed auto
command.
Link speed type is force link
The interface is manually configured with a speed (for example,
1000 Mbps) by using the
speed
command.
link duplex type is autonegotiation
The interface is configured with the
duplex auto
command.
link duplex type is force link
The interface is manually configured with a duplex mode (for
example, half or full) by using the
duplex
command.
Flow-control is not enabled
Generic flow control is disabled on the interface. This field
depends on your configuration and the link parameter negotiation
result.
Maximum frame length
Maximum length of Ethernet frames allowed to pass through the
interface.
Allow jumbo frame to pass The interface allows jumbo frames to pass through.
Broadcast max-
Broadcast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
To Next Page
Loading...
Need help?
General