HPE FlexNetwork 5130 EI Series User Manual

13
Field Description
Multicast max-
Multicast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Unicast max-
Unknown unicast storm suppression threshold in ratio, pps, or
kbps. The unit of the threshold depends on your configuration.
PVID Port VLAN ID (PVID) of the interface.
MDI type
MDIX mode of the interface:
• automdix.
• mdi.
• mdix.
Port link-type
Link type of the interface:
• access.
• trunk.
• hybrid.
Tagged VLANs
VLANs for which the interface sends packets without removing
VLAN tags.
Untagged VLANs
VLANs for which the interface sends packets after removing
VLAN tags.
VLAN Passing
VLANs whose packets can be forwarded by the port. The VLANs
must have been created.
VLAN permitted VLANs whose packets are permitted by the port.
Trunk port encapsulation Encapsulation protocol type for the trunk port.
Last link flapping
The amount of time that has elapsed since the most recent
physical state change of the interface. This field displays
Never
if
the interface has been physically down since device startup.
Last clearing of counters
Time when the
reset counters interface
command
was last used to clear the interface statistics. This field displays
Never
if the
reset counters interface
command has
never been used on the interface since device startup.
Last 300 second input: 0 packets/sec 0
bytes/sec 0%
Last 300 second output: 0 packets/sec
0 bytes/sec 0%
Average inbound or outbound traffic rate (in pps and Bps) in the
last 300 seconds, and the ratio of the actual rate to the interface
bandwidth.
A hyphen (-) indicates that the statistical item is not supported.
Input(total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0
multicasts, 0 pauses
The two fields on the first line represent the inbound traffic
statistics (in packets and bytes) for the interface. All inbound
normal packets, abnormal packets, and normal pause frames
were counted.
The four fields on the second line represent:
• Number of inbound unicast packets.
• Number of inbound broadcasts.
• Number of inbound multicasts.
• Number of inbound pause frames.
A hyphen (-) indicates that the statistical item is not supported.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English