ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Copyright © Huawei Technologies Co., Ltd.
2. Click the Security tab.
3. Click Internet.
4. Click Custom level.
The Security Settings-Internet Zone
dialog box is displayed.
5. Set Automatic prompting for ActiveX
controls to Enable, and set Download
unsigned ActiveX controls and
Initialize and script ActiveX controls
not marked as safe for scripting to
Prompt.
6. Click OK.
Enable TLS 1.1 or TLS 1.2.
NOTE
You must enable TLS 1.1 or TLS 1.2 when the
Hypertext Transfer Protocol Secure (HTTPS)
protocol is used to access the IPC. Otherwise the
camera web interface cannot be accessed.
1. Choose Tools > Internet Options.
The Internet Options dialog box is
displayed.
2. Click the Advanced tab.
3. Select Use TLS 1.1 or Use TLS 1.2.
4. Click OK.
Set Use Pop-up Blocker to Disable.
1. Choose Tools > Internet Options.
The Internet Options dialog box is
displayed.
2. Click the Security tab.
3. Click Internet.
4. Click Custom level.
The Security Settings-Internet Zone
dialog box is displayed.
5. Set Use Pop-up Blocker to Disable.
6. Click OK.
Step 2 For details about how to commission IP cameras and set parameters for them, see the
documentation delivered with the equipment or obtain the documentation by referring to the
"Preparing Documentation" section.
1. Preview the site situation in real time and check the camera coverage through videos.
Adjust the lens if necessary.
2. Choose Settings > Network Configuration > Network Parameters, and set IPv4
address, IPv4 Subnet mask, and IPv4 Gateway address for the camera according to
the site plan.
3. Choose Settings > Video/Audio/Image > Video Settings, and set camera stream type,
primary stream, and secondary stream 1 parameters.
To Next Page
Loading...
