Huawei ECC800 - How Should I Add Devices Accessed through the ETH Converter to the ECC800-Pro Webui

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
8 FAQ
Issue 06 (2020-04-22)
Copyright © Huawei Technologies Co., Ltd.
283
8.1.27 How Should I Add Devices Accessed Through the ETH
Converter to the ECC800-Pro WebUI?
Context
Figure 8-32 Network diagram
Procedure
Step 1 Set communications parameters on the device.
Table 8-39 Description of communications parameters to be set on a device
Parameter
Recommended Value
Baud rate
This section uses 9600 as an example. Set this parameter
based on site requirements.
NOTE
For certain devices, this parameter does not need to be set.
Communications address
This section uses 1 as an example. Set this parameter based on
site requirements.