ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Copyright © Huawei Technologies Co., Ltd.
Settings, click
Unhide All
Advanced Signals,
click Power Supply
Parameters.
Step 3 After setting all mandatory parameters, click Submit.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800-Pro WebUI, and drag the device to the
corresponding position in the Smart Module View pane based on the actual device layout.
8.1.30 How Do I Add an RS485 Device Connected to the
ECC800-Pro Through a UIM?
Prerequisites
This section uses the device (such as a T/H sensor, rPDU, cabinet electronic lock, and U-bit
manager) connecting to the COM1 port on the UIM20A expansion module as an example.
Procedure
Step 1 Set communications parameters on the device.
Table 8-44 Description of communications parameters to be set on a device
This section uses 9600 as an example. Set this parameter
based on site requirements.
NOTE
For certain devices, this parameter does not need to be set.
This section uses 1 as an example. Set this parameter based on
site requirements.
Step 2 Add the device to the ECC800-Pro WebUI.
1. Log in to the ECC800-Pro WebUI as an administrator.
2. Add the device.
Choose System Settings > Device Management and click Auto Discover Device to add
the device. The device connection information is displayed.
To Next Page
Loading...
