Huawei ECC800 - 7.3 Component Replacement

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
6 Feature Description
Issue 06 (2020-04-22)
Copyright © Huawei Technologies Co., Ltd.
202
----End
6.14.1.2 Setting NetEco Parameters
When the smart module can be connected to the NetEco, perform the following steps to
configure parameters.
Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800-Pro WebUI.
Table 6-46 IP parameters
Path
Parameter
Default
Value
Setting
System
Settings >
System
Parameters
> Monitor
IP >
WAN_1
IP
192.168.8.10
Set this parameter based on the IP address
assigned by the network administrator.
Subnet mask
255.255.255.
0
Set this parameter based on the subnet mask
assigned by the network administrator.
Default
gateway
192.168.8.1
Set this parameter based on the default
gateway address assigned by the network
administrator.
Step 3 Click Submit.
Step 4 Set NetEco communications parameters and authentication password on the ECC800-Pro
WebUI.
Table 6-47 NetEco parameters
Path
Parameter
Default
Value
Setting
System
Settings >
NMS
Application >
NetEco >
Communicati
on
Parameters
NetEco
Location
Local
Set this parameter based on the type of
the connected NetEco management
system.
Local: NetEco
Cloud: CloudOpera NetEco
Server IP
192.168.8.1
1
IP address of the primary NetEco server
NOTE
The NetEco IP address and the ECC800-Pro
IP address must be configured in the same
network to ensure normal connection
between the NetEco and the ECC800-Pro.
Port number
31220
31220
Network IP for
WAN_1
WAN_1 or WAN_2