ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Copyright © Huawei Technologies Co., Ltd.
After you open the Huawei AppGallery, select NOT NOW if "New Version" is displayed.
Log in to the ECC800-Pro WebUI using a PC. Choose Maintenance > App Obtaining,
scan QR code, and save the app installation package to the PC or a path on the mobile
storage device. Then, copy the app installation package to a mobile phone or pad.
When the WiFi is enabled, enter https://192.168.245.10 in the address bar of the Firefox
browser (version 41.0 or later) on a mobile phone or pad, and press Enter to access the
ECC800-Pro WebUI. Choose Maintenance > App Obtaining and scan QR code to save
the app package to the mobile phone or pad.
Step 2 Install the app.
By default, the Android operating system forbids the installation of apps not obtained from the
Android market. Therefore, before installing the app, set the mobile phone so that it allows
the installation of apps from unknown sources.
1. Tap the app installation file for installation. After the installation is complete, check that
the app icon is displayed on the home screen of the mobile phone or pad.
Step 3 Hold down the SW button on the ECC800-Pro for less than 3s to enable the WiFi function.
The initial password is Changeme after the WiFi function is enabled. The password is valid only
after you hold down the button for the first time to enable the WiFi function. If you enable the WiFi
function on the WebUI, there is no preset password.
After the WiFi function is enabled, the password for a mobile phone to connect to the WiFi network
is Changeme. When you log in to the app using a tablet, the system prompts you to change the
password.
After you disable the WiFi hotspot function on the WebUI and press the button again, the WiFi
function is still enabled. In this case, the WiFi password is the one you changed last time.
The WiFi function is disabled by default. If you need to enable the WiFi function, change the WiFi
password to ensure connection security.
A password that has been used for a long time is more likely to be stolen or cracked. The risk
increases along with the time of use. Change the WiFi password periodically (recommended: once
half a year).
Step 4 (Optional) Enable the WiFi function on the ECC800-Pro WebUI.
1. Log in to the ECC800-Pro WebUI as an administrator.
2. Choose Monitoring > System > WiFi Converter and click WiFi Management.
3. Set Enable WiFi to Enable and click Submit.
4. If this is the first time you enable the WiFi function, set WiFi Password and click OK.
5. Enter the password currently used for logging in to the WebUI and click Submit.
6. Specify WiFi SSID and WiFi Password and click Submit to change the SSID and
password.
If you have set a password when enabling WiFi for the first time, you do not need to set the
password again.
To Next Page
Loading...
