Huawei iMaster NetEco V600R021C10 User Manual

Parameter Description
Connection Mode Connection mode of a device. You can set this parameter to
Non-SSL Connection or SSL Connection.
If you modify the connection mode on the NetEco, you
must modify the connection mode on the device WebUI
accordingly.
NOTE
● Connection Mode for the NetEco and device must be the same.
● By default, Connection Mode is set to SSL Connection for the
NetEco and device.
● A non-SSL connection has security risks. You are advised to
select the secure SSL connection.
NOTE
Battery detectors accessed through the UPS do not support device
software management.
Authentication
Password
Re-authentication password for the NetEco and device.
1. Click Modify.
NOTE
After the device is saved, the Modify button is displayed.
2. In the displayed dialog box, enter the New Password
and Conrm Password.
NOTE
– The default re-authentication password for the NetEco and
device is Modifyme_123.
– The device password should be consistent with the NetEco
password.
– If the password does not meet requirements, modify it on
the device.
3. Select a value for Send To Device.
NOTE
If you select YES, the re-authentication password for the NetEco
and device is changed at the same time. If you select NO, only
the re-authentication password of NetEco is changed on the
server.
4. Click OK.
Timeout Period Timeout duration for a connection test. The default value is
3s.
Step 8 Click
on the toolbar to save the device information.
Step 9 Click Connection test to start the connection test.
----End
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 165

Huawei iMaster NetEco V600R021C10 Specifications

General

Brand	Huawei
Model	iMaster NetEco V600R021C10
Category	Network Hardware
Language	English