Huawei iMaster NetEco V600R021C10 - Page 257

Parameter Conguration Operation
Setting 1. Click Setting. The Setting Rule dialog box is displayed.
Figure 6-73 Setting Rule
2. Set the real-time value, which is the same as the real-time
signal.
3. Click OK.
Counter
1. Click ... next to Counter. The Select Data dialog box is
displayed.
2. Set Object and Counter to be added.
3. Click OK.
NOTE
After the managed object and counter are bound, you can
remotely open and close a door using the door status sensor icon.
1. Click the door status sensor icon and choose Close or Open
under .
2. In the displayed dialog box, click Yes.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 246