Huawei Quidway S9300

See the configuration of Switch A.
# Configure Switch C.
See the configuration of Switch A.
Step 2 Configure the management addresses of Switch A, Switch B, and Switch C.
# Configure Switch A.
[SwitchA] lldp management-address 10.10.10.1
# Configure Switch B.
[SwitchB] lldp management-address 10.10.10.2
# Configure Switch C.
[SwitchC] lldp management-address 10.10.10.3
Step 3 Verify the configuration.
# Check whether LLDP is enabled and whether the management address is configured on each
switch.
l Check the configuration of Switch A.
<SwitchA> display lldp local
System
information
Chassis
type :macAddress
Chassis ID :00e0-
fc33-0011
System name :SwitchA
System description :Quidway
S9303
Huawei Versatile Routing Platform
Software
VRP (R) Software, Version 5.70 (S9300
V100R003C00B042)
Copyright (c) 2003-2010 Huawei Technologies Co.,
Ltd
System capabilities
supported :bridge
System capabilities
enabled :bridge
LLDP Up time :2009/2/13
18:31:37
MED system information
Device class :Network Connectivity
(MED inventory information of master board)
HardwareRev :LE02SRUA VER.A
FirmwareRev :NC
SoftwareRev :Version 5.70 V100R003C00B042
SerialNum :NA
Manufacturer name :NA
Model name :NA
Asset tracking identifier :NA
System configuration
LLDP Status :enabled (default is disabled)
LLDP Message Tx Interval :30 (default is 30s)
LLDP Message Tx Hold Multiplier :4 (default is 4)
LLDP Refresh Delay :2 (default is 2s)
LLDP Tx Delay :9 (default is 2s)
LLDP Notification Interval :10 (default is 5s)
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 4 LLDP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-29