EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
630 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l IP address of the remote peer
Procedure
Step 1 Configure a dynamic single-hop PW.
Configure a dynamic single-hop PW on the MPLS backbone network.
For the detailed configuration procedure, see "PWE3 Configuration" in the Quidway S9300
Terabit Routing Switch Configuration Guide - VPN.
Step 2 Configure a PWE3 Ping test of the single-hop PW.
# Configure PE-A.
<PE-A> system-view
[PE-A] nqa test-instance test pwe3ping
[PE-A-nqa-test-pwe3ping] test-type pwe3ping
[PE-A-nqa-test-pwe3ping] local-pw-id 100
[PE-A-nqa-test-pwe3ping] local-pw-type vlan
[PE-A-nqa-test-pwe3ping] label-type control-word
Step 3 Perform the test.
[PE-A-nqa-test-pwe3ping] start now
Step 4 Verify the test result.
After running the display nqa results command on the PE device, you can see that the test is
successful.
[PE-A-nqa-test-pwe3ping] display nqa results
NQA entry(test, pwe3ping) :testFlag is inactive ,testtype is pwe3ping
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Min Positive Jitter: 0 Min Negative Jitter: 0
Max Positive Jitter: 0 Max Negative Jitter: 0
Positive Jitter Num: 0 Negative Jitter Num: 0
Positive Jitter Sum: 0 Negative Jitter Sum: 0
Positive Jitter Square Sum: 0 Negative Jitter Square Sum: 0
Packet Loss: 0 Packet Loss Ratio: 0
Destination ip address:10.2.2.2
Min/Max/Average Completion Time: 60/110/86
Sum/Square-Sum Completion Time: 260/23800
Average Single-Way Completion Time: 30
Last Good Probe Time: 2008-9-29 14:35:43.2
----End
Configuration Files
l Configuration file of CE-A
#
sysname CE-A
#
vlan batch 110
#
interface Vlanif110
ip address 100.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-206 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals