Huawei Quidway S9300

[SwitchA-nqa-admin-jitter] destination-address ipv4 30.1.1.2
[SwitchA-nqa-admin-jitter] destination-port 9000
Step 3 Configure the NQA thresholds.
# Configure the RTD threshold on Switch A.
[SwitchA-nqa-admin-jitter] threshold rtd 20
# Configure the OWD-DS threshold on Switch A.
[SwitchA-nqa-admin-jitter] threshold owd-ds 100
# Configure the OWD-SD threshold on Switch A.
[SwitchA-nqa-admin-jitter] threshold owd-sd 100
Step 4 Enable the function of sending trap messages.
[SwitchA-nqa-test-jitter] send-trap owd-ds owd-sd rtd
[SwitchA-nqa-test-jitter] quit
Step 5 Configure the function of sending trap messages to the NMS.
[SwitchA] snmp-agent trap enable
[SwitchA] snmp-agent sys-info version v2c
[SwitchA] snmp-agent target-host trap address udp-domain 20.1.1.2 params
securityname public v2c
Step 6 Perform the test.
[SwitchA] nqa test-instance admin jitter
[SwitchA-nqa-admin-jitter] start now
[SwitchA-nqa-admin-jitter] quit
[SwitchA] quit
Step 7 Verify the configuration.
# Verify the NQA test result of each Switch.
<SwitchA> display nqa result
NQA entry(test, jitter) :testflag is inactive ,testtype is jitter
1 . Test 1 result The test is finished
Send operation times:3000 Receive response times:3000
Completion :success RTD RTD OverThresholds number:25
OWD OverThresholds SD number:7 OWD OverThresholds DS number:7
Min/Max/Avg/Sum RTT:1/26/1/3143 RTT Square Sum:5665
NumOfRTT:3000 Drop operation number:0
Operation sequence errors number:0 RTT Stats errors number:0
System busy operation number:0 Operation timeout number:0
Min Positive SD:1 Min Positive DS:0
Max Positive SD:27 Max Positive DS:0
Positive SD Number:1890 Positive DS Number:0
Positive SD Sum:2128 Positive DS Sum:0
Positive SD Square Sum :4864 Positive DS Square Sum :0
Min Negative SD:1 Min Negative DS:1
Max Negative SD:16 Max Negative DS:2
Negative SD Number:38 Negative DS Number:1936
Negative SD Sum:129 Negative DS Sum:1998
Negative SD Square Sum :1445 Negative DS Square Sum :2122
Max Delay SD:13 Max Delay DS:12
Packet Loss SD:0 Packet Loss DS:0
Packet Loss Unknown:0 Average of Jitter:1
Average of Jitter SD:1 Average of Jitter DS:1
jitter out value:0.7489559 jitter in value:0.6627117
NumberOfOWD:3000 Packet Loss Ratio: 0%
OWD SD Sum:81 OWD DS Sum:62
# Verify that a trap message is generated in the trap buffer.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-230 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)