v 2.3 — September 2015 Altanium Delta3
116 Setting the Remote Standby Duration Timer
To set the manual standby duration timer, do the following:
1. On the System Setup screen, under Manual Standby and Boost, touch the Manual
Standby Duration Timer field.
2. Enter the time required in the format HHMMSS.
3. Touch the Accept button.
10.1.7.2 Setting the Remote Standby Duration Timer
The zone temperature decreases for a given time duration or until a set remote standby
temperature is achieved.
NOTE:If the system is not equipped with the remote standby feature, only the Manual
Standby Duration Timer setting is displayed on the System Setup screen.
To set the remote standby duration timer, do the following:
1. On the System Setup screen, under Remote Standby, touch the Remote Standby
Duration Timer field.
2. Enter the time required in the format HHMMSS.
3. Touch the Accept button.
10.1.7.3 Setting the Remote Standby Delay Timer
The remote standby delay timer is a feature available with remote standby. Use the remote
standby delay timer to protect the material from burning if the molding machine is stopped
for a specified period. If the remote standby delay timer is set, Altanium will not decrease the
temperatures until the delay time has elapsed.
For example, when the operator gate on the molding machine is opened, a signal to start the
remote standby delay timer could be sent to Altanium. If the operator gate is closed before
the delay time has elapsed, Altanium will not enter standby. If the operator gate remains
open, Altanium then enters standby.
NOTE:If the system is not equipped with the remote standby feature, only the Manual
Standby Duration Timer setting is displayed on the System Setup screen.
To set the remote standby delay timer, do the following:
1. On the System Setup screen, under Remote Standby, touch the Remote Standby
Delay Timer field.
2. Enter the time required in the format HHMMSS.
3. Touch the Accept button.
10.1.7.4 Changing the Remote Standby Input Mode
The remote standby input mode setting is enabled based on one of three settings: trigger,
on/off, or direct.
To Next Page
Loading...
