v 2.3 — September 2015 Altanium Delta3
126 Diagnostics Export
10.1.13 Diagnostics Export
Diagnostics Export allows users to export diagnostics files to a USB drive. This feature is
intended for Husky Technical Support use only. Please contact Husky for assistance if
required.
10.1.14 Part Counting
Optional digital inputs and an output are available to automatically count up parts, including
the ability to set a sack full limit. This eliminates the need for users to manually calculate
when sack is full.
10.1.14.1 Setting Up Part Counting
To set up Part Counting, do the following:
1. On the System Setup screen, under Part Counting, select Setup. A dialog box will
appear.
2. Select Assign Heater Types if not previously done. This will bring up the Quick Set
screen. For more information refer to Section 7.5.8.
Figure 10-9 Options and Licensing
1. Options and Licensing
1
To Next Page
Loading...
