Husky Altanium Delta3 - Replacing the Motherboard Battery

Replacing the Motherboard Battery 189
User Guide v 2.3 — September 2015 Maintenance
4. Install the 4 mounting feet into the display module. Use the threaded holes where the
mounting plate screws were removed in step 1.
5. Place the display module in the mounting location.
6. Facing the rear of the system, connect the detachable extension Power and Input Comm
cables to the mainframe.
NOTE:The main power for the Altanium display module can only come from the
mainframe Display Power connection.
15.5 Replacing the Motherboard Battery
The motherboard uses a Button Cell CR2032 battery.
To replace the motherboard battery, do the following:
Figure 15-14 Installing the Delta3 Mounting Feet to the Display Module
1. Mounting Feet
1
WARNING!
Electrical and mechanical hazard - risk of death, serious injury and/or damage to the
equipment. Turn off all power to the system and disconnect it completely from the
main input power.
Use a ground strap when handling any of the Altanium components.