v 2.3 — September 2015 Altanium Delta3
162 Filtering by Units
12.3.1 Filtering by Units
To filter based on units of measure, do the following:
1. On the Process Target screen, touch the Units Filter field. The Units Filter dialog box
appears.
2. Touch the desired unit of measure.
3. Touch the Close button.
Stop Controller If selected, the controller will stop if any critical process variable is not within
the lower and upper limits.
Digital Output On If selected, a digital output will trigger if any process variable is not within the
lower and upper limits. For more information, refer to the Digital I/O screen.
Delay Limit Check If selected, process targets will not be checked until all zones are at
temperature. The timer then will start. Once the time expires, the targets will
be checked according to their settings.
Limit Definition
Figure 12-9 Units Filter Dialog Box
To Next Page
Loading...
