Loading an Existing Mold Setup File 55
User Guide v 2.3 — September 2015 Mold Setups
6.1.6 Loading an Existing Mold Setup File
After a Mold Setup file has been created it is automatically loaded as the current Mold Setup
in the system.
To load a different Mold Setup, do the following:
1. On the Mold Setup screen, select the Mold Setup folder that contains the Mold Setup
file to be loaded.
2. Touch the name of the mold setup file to be loaded.
3. Touch the Load Mold Setup button to load the selected mold setup.
Once a mold setup is loaded, its name will be displayed at all times on the Mold Setup
Info button in the System Footer.
6.1.7 Deleting Files
When a file or folder is no longer required on the internal disk, it can be deleted.
To delete a file or folder, do the following:
1. On the Mold Setup screen, touch the file or folder to be deleted.
2. Touch the Delete button.
3. A message appears asking to confirm the deletion. To continue, touch the Accept
button. To cancel the deletion, touch the Cancel button.
6.1.8 Copying Files
Mold setups, images, documents or notes can be copied from one folder or device to
another. Only files from folders with the same name or type can be copied into that folder.
For example: a mold setup file can be pasted only into a mold setup folder.
To copy and paste a file, do the following:
1. On the Mold Setup screen, touch the file to be copied.
2. Touch the Copy button.
3. Navigate to the destination folder, and then touch the Paste button to create a copy of
the file.
6.1.9 Renaming Files
To rename a file or folder, do the following:
1. On the Mold Setup screen, touch the file or folder to be renamed.
2. Touch the Rename button and enter the new name.
3. Touch the Accept button to save the name of the file.
To Next Page
Loading...
