Husky Altanium Delta3 - Boost Operation Description; Changing the Remote Boost Input Mode; Setting the Remote Boost Delay Timer

Setting the Remote Boost Delay Timer 119
User Guide v 2.3 — September 2015 System Setup Screen
To set the remote boost duration timer, do the following:
1. On the System Setup screen, under Remote Boost, touch the Remote Boost Duration
Timer field.
2. Enter the time required in the format HHMMSS
3. Touch the Accept button.
10.1.8.3 Setting the Remote Boost Delay Timer
Use the remote boost delay timer to wait for a specified period before entering boost.
To set the remote boost delay timer, do the following:
1. On the System Setup screen, under Remote Boost, touch the Remote Boost Delay
Timer field.
2. Enter the time required in the format HHMMSS.
3. Touch the Accept button.
10.1.8.4 Changing the Remote Boost Input Mode
The remote boost input mode setting is enabled based on one of three settings: trigger,
on/off, or direct.
To change the Boost Input, do the following:
1. On the System Setup screen, under Remote Boost, touch the Remote Boost Input
Mode field.
2. Select the desired setting.
NOTE:If the system is not equipped with remote boost, the Remote Boost Input Mode field
will not appear.
10.1.8.5 Boost Operation Description
Manual Boost can be cancelled at any time by touching the Start or Stop buttons.
Table 10-4 Manual Boost Operational Description
Manual
Time
Delay
Time
Remote
Time
Input
Mode
Cycle
Enabled
Operation - BOOST Button
Select
0:00:00 ---- ---- ---- ---- System enters Boost indefinitely.
X:XX:XX ---- ---- ---- ---- System remains in Boost until the
timer expires.