Husky Altanium Delta3 - Using the Mold Picture View Toolbar

v 2.3 — September 2015 Altanium Delta3
144 Using the Mold Picture View Toolbar
11.2 Using the Mold Picture View Toolbar
Use the Mold Picture View toolbar to change the view of the mold picture view graphic. To
hide/show the Mold Picture View toolbar, touch the screen.
NOTE:The Mold Picture View toolbar is not available in Edit mode.
Figure 11-4 Mold Picture View Screen
1. Zoom Out Button 2. Zoom In Button 3. Fit Width Button 4. Fit Height Button 5. Original
Size Button 6. Mold Picture View Graphic 7. Views
Toolbar Button Definition
Zoom Out Button Demagnifies the mold picture view graphic.
Zoom In Button Magnifies the mold picture view graphic.
Fit Width Button Fits the mold picture view graphic to the widest width possible while
retaining the entire graphic on the screen.
Fit Height Button Fits the mold picture view graphic to the tallest height possible while
retaining the entire graphic on the screen.
Original Size
Button
Fits the mold picture view graphic to the default size.
Views Selects the mold picture view graphic associated with that view.
1
2
3
4
5
6
7