Husky Altanium Delta3 - Technical Specifications; Controller Lifting Instructions

Technical Specifications 5
User Guide v 2.3 — September 2015 Introduction
1.7 Technical Specifications
The dimensions and weight of the controller can change based on the controller
configuration.
The following are the technical specifications for the Altanium Delta3 operator interface only:
1.8 Controller Lifting Instructions
Use the follow steps when lifting the Altanium controller. The lifting device (crane or forklift)
and straps that are used vary in lifting ability and lengths, depending on whether the
Altanium is a single, double, or triple stack controller. See the table that follows for the correct
lifting ability and lengths.
1. Place each of the webbed straps under the controller. See the table for the correct strap
lengths.
a. For single stack controllers, the webbed straps go under the equipment from left to
right.
b. For double and triple stack controllers, the webbed straps go under the equipment
from front to back.
2. Bring the straps up and above the Altanium controller and attach them to the lifting
device.
Dimensions Weight
• Width: 330 mm (13 in)
• Length: 280 mm (11 in)
• Height: 380 mm (15 in)
• Controller: 6.8 kg (15 lb)
• With shipping container: 10 kg (22 lb)
Altanium
Controller
Webbed Straps Rated
2903 kg (6400 lb)
Ratchet Strap
Lifting Device
(Lifting Ability)
Single Stack Two, 2.44 m x 25.4 mm
(8 ft x 1 in.)
One, 1.52 m (5 ft) 227 kg (500 lb)
Double Stack Two, 3.66 m x 25.4 mm
(12 ft x 1 in.)
One, 1.83 m (6 ft) 454 kg (1000 lb)
Triple Stack Two, 3.66 m x 25.4 mm
(12 ft x 1 in.)
One, 2.44 m (8 ft) 907 kg (2000 lb)