Husky Altanium Delta3 - Manual Control Buttons; Ready Conditions

Manual Control Buttons 197
User Guide v 2.3 — September 2015 UltraSync-E, If Equipped
16.3.2 Manual Control Buttons
Use the Manual Control buttons to indicate current position of the stems, change the
position of the valve gates and to calibrate UltraSync-E.
16.3.3 Ready Conditions
Use the ready conditions status indicators to determine what steps are required to put
UltraSync-E into Engaged mode.
Disengaged Button
Activates Disengaged mode, where UltraSync-E is controlled by the operator
using the Altanium user interface.
Disabled Button
The UltraSync-E servo system is disabled.
Item Description
Item Description
Close Valve Gates
This button closes the valve gates. When the stems are at close position, the
button is highlighted with a yellow outline.
Open Valve Gates
This button opens the valve gates. When the stems are at open position, the
button is highlighted with a yellow outline.
Calibrate
This button starts the calibration sequence.