Calibrating the Thermocouple Inputs 191
User Guide v 2.3 — September 2015 Maintenance
15.6 Calibrating the Thermocouple Inputs
The system has been factory-calibrated and in most cases it is not necessary to recalibrate
until Altanium has been running for one year. If calibration is necessary, please contact the
nearest Husky Regional Service and Sales office for calibration instructions.
15.7 Cleaning the System
15.7.1 Cabinet
• Use a damp sponge or cloth. No abrasives should ever be used on the surface. The labels
should also be wiped and no cleaners or solvents should be used.
• If a cleaner of any type must be used, window cleaner sprayed onto a cloth, not directly
onto the cabinet, is recommended.
15.7.2 Touch Screen
1. Make sure the monitor is turned off.
2. Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles.
3. If necessary, apply a small amount of non-ammonia, non-alcohol based glass cleaner
onto a clean, soft, lint-free cloth, and wipe the screen.
CAUTION!
Mechanical hazard – risk of equipment damage. Do not spray or pour any liquid
directly onto the screen or case. Spray cleaner onto a lint-free cloth. If the liquid
droplets dry on the monitor, the liquid may permanently stain or discolor the monitor.
CAUTION!
Mechanical hazard – risk of equipment damage. The display area is highly prone to
scratching. Do not use ketone type material (e.g. acetone), ethyl alcohol, toluene, ethyl
acid or methyl chloride to clear the panel. These products may permanently damage
the panel and void the warranty.
To Next Page
Loading...
