Force Temperature Units To Option 113
User Guide v 2.3 — September 2015 System Setup Screen
10.1.1 Force Temperature Units To Option
Users can select how the available temperature units are displayed using the Force
Temperature Units To option: Degrees Celsius (C), degrees Fahrenheit (F), or degrees kelvin
(K).
When C, F or K is selected, all temperature units in the system will be forced to be displayed
in the respective unit, including all stored mold setups. If a dash is shown, then the user may
select any of the temperature unit choices in the units dialog.
1. On the System Setup screen, under User Settings, touch the Force Temperature
Units To button.
2. Select the desired unit.
10.1.2 Data Collection
Users can specify how often process data will be sampled. Click on the icon to open the
dialog box and enter the desired time.
1. On the System Setup screen, under Data Collection, touch the Interval button.
2. Enter the desired time interval in seconds.
3. Touch the Accept button.
Figure 10-2 Force Temperature Units To
1. Force Temperature Units To
To Next Page
Loading...
