v 2.3 — September 2015 Altanium Delta3
112 System Setup Screen
Soft Start Enable Toggle this parameter on or off. If this parameter is on, the soft
start process is applied upon startup.
Soft Start Minimum Limit Once the soft start process is initiated, the system calculates the
difference between the zone with the highest and lowest
temperatures. If this difference is less than this parameter value,
then this parameter value is applied to the soft start process.
Energy Cost Rate Energy cost accumulated per Kwh.
Currency Type Currency for energy cost rate.
Grid Size To change the mainframe layout on the Card Layout screen,
change the grid size.
Group Offset Use the group offset setting to configure the linked systems. The
default group offset setting is 96 zones.
Wattage Voltage Insert the designed voltage rating of the heaters so the system can
accurately calculate Watt Voltage.
Supply Configuration Used to select the supply configuration parameter: Delta 3PH,
Wye 3PH+N, Single Phase, or Integrated TX.
Alarm Sensitivity The duration of time the system has to stay in an error condition
before it is declared an alarm.
Maximum Temperature Limit The number of degrees over the setpoint the Maximum
Temperature Alarm is activated.
No Response Limit A global setting that determines how long the system should
apply 96% power or greater without a 5 degree rise in
temperature before it is declared an alarm condition.
At Temperature Minimum
Limit
Defines the minimum threshold for activating the At-
Temperature signal.
Mold Cooling Enable Limit Defines the threshold the system uses to determine when to
activate or deactivate the Mold Cooling Enable output.
Part Counting Used to automatically count up parts with the ability to set a sack
full limit.
Remote Load Used to select the mold setups that can be loaded directly from
the injection molding machine.
SPI If a device is attached to the SPI connector, this section allows the
user to enable communication with the device and set
communication protocol.
Table 10-1 System Setup Screen Item Descriptions (Continued)
Item Description
To Next Page
Loading...
