Husky Altanium Delta3 - Creating a New Mold Setup Folder; Creating a New Mold Setup File

Creating a New Mold Setup Folder 53
User Guide v 2.3 — September 2015 Mold Setups
6.1.1 Creating a New Mold Setup Folder
Use a Mold Setup folder to store multiple mold setup files.
To create a new Mold Setup folder, do the following:
1. Touch the New Folder button.
2. Enter the name of the new mold folder.
3. Touch the Accept button.
The new Mold Setup folder is now displayed under the Molds directory.
6.1.2 Creating a New Mold Setup File
Once a Mold Setup folder has been created, a new mold setup file can be added to it.
When a new mold setup file is created, and the Default folder contains only the Default mold
setup file, the factory default setup file is copied and used as a starting point.
Touch the Discard Changes button to revert the currently loaded mold
setup file to the state after it was last saved (using the Save Mold Setup
button). All unsaved changes will be discarded. This action only pertains to
the loaded mold setup file regardless of what is selected on the screen.
Touch the Copy button to copy mold setups, images or documents.
Touch the Paste button to paste copied mold setups, images, documents
or notes from one folder or device to another.
Touch the Delete button to delete a mold folder, mold setup, image or
document. A confirmation message is shown. This button is not available
unless a folder or file is selected.
Touch the Rename button to display a keyboard to rename a mold folder,
mold setup, image, note or document. This button is not enabled unless a
file or folder is selected.
Touch the Preview button to display mold setup files, images, and
documents.
Table 6-2 Mold Setup Screen Button Descriptions (Continued)
Button Description