Husky Altanium Delta3 - Standby Operation Description

Standby Operation Description 117
User Guide v 2.3 — September 2015 System Setup Screen
To change the remote standby input mode, do the following:
1. On the System Setup screen, under Remote Standby, touch the Remote Standby
Input Mode field.
2. Select the desired setting.
NOTE:This setting will not appear if the remote standby option is not available on the
system.
10.1.7.5 Standby Operation Description
To cancel the manual standby duration timer at any time, touch the Start or Stop buttons.
Table 10-2 Manual Standby Operational Description
Manual
Time
Delay
Time
Remote
Time
Input
Mode
Cycle
Enabled
Operation - STANDBY Button
Select
0:00:00 ---- ---- ---- ---- System enters Standby indefinitely.
X:XX:XX ---- ---- ---- ---- System remains in Standby until the
timer expires.
Table 10-3 Remote Standby Operational Description
Manual
Time
Delay
Time
Remote
Time
Input
Mode
Cycle
Enabled
Operation - STANDBY Button
Select
---- 0:00:00 0:00:00 Trigger ---- System will not enter Standby since no
timers are set.
---- 0:00:00 X:XX:XX Trigger ---- System immediately enters and
remains in Standby until the timer
expires.
---- X:XX:XX X:XX:XX Trigger No System delays for specified time and
then enters Standby until the timer
expires.
---- X:XX:XX 0:00:00 Trigger No System delays for specified time and
then enters Standby indefinitely.
---- X:XX:XX X:XX:XX Trigger Yes System delays for specified time and
then enters Standby until the timer
expires. If the input signal changes
state while delay timer is active, the
delay timer is reset to the specified
value.
---- X:XX:XX 0:00:00 Trigger Yes System delays for specified time and
then enters Standby indefinitely. If the
input signal changes state while the
delay timer is active, the delay timer is
reset to the specified value.