Husky Altanium Delta3 - Replacing the Motherboard Battery

User Guide v 2.3 — September 2015 Maintenance
Altanium System 177
Chapter 15 Maintenance
This chapter describes the maintenance tasks required to maintain the Altanium Delta3
system. The following maintenance procedures are to be performed only when needed.
Periodically and before starting the equipment check that all cables and cable connections
are free from wear or damage. Do not operate equipment if the cables are damaged. Replace
any cables that appear damaged.
The following maintenance procedures are to be performed only when needed.
15.1 Altanium System
The Altanium X/H-Series systems are based around a modular concept. The two major
components for the X/H-Series systems are the Altanium operator interface and the X-Series
(12 - zone) card cage or H-Series (24-zone) card cage. Both X-Series and H-Series card cages
house six Intelligent Control Cards.
The Altanium display is used to enter and display molding parameters. The display does not
contain user-serviceable parts.
Procedure Reference
Replacing an Intelligent Control Card (ICC
2
or ICC
3
) Section 15.3.2
Replacing a Blown Fuse on an ICC
2
or ICC
3
Section 15.3.3
Replacing the Altanium Delta3 Display Module Section 15.4
Replacing the Motherboard Battery Section 15.5
Cleaning the System Section 15.7
Figure 15-1 Altanium Operator Interface
1. Front view 2. Side view 3. Back view
1 2 3