User Guide v 2.3 — September 2015 Mold Picture View
Loading a Mold Picture View Graphic 141
Chapter 11 Mold Picture View
This chapter describes how to use the mold picture view.
11.1 Loading a Mold Picture View Graphic
Load a mold picture view graphic from one of the following locations:
• the local drive
• a USB drive
• the network
11.1.1 Mapping a Network Drive
If loading a mold picture view graphic from the network, make sure Altanium is mapped to a
valid network drive.
To map a network drive, do the following:
1. On the Home screen, touch the Network Setup button.
2. In the Network Locations field, type a valid network location.
11.1.2 Loading a Mold Picture View Graphic
Altanium is capable of displaying up to five different images in the mold picture view. Use
this procedure to upload new mold picture view graphics.
To load a mold picture view graphic, do the following:
1. On the Home screen, touch the Mold Picture View button.
NOTE:If changing an existing mold picture view graphic, touch the name of the view
containing the mold picture view graphic to be changed.
To Next Page
Loading...
