v 2.3 — September 2015 Altanium Delta3
54 Saving Changes to a Mold Setup File
If the Default folder contains a user supplied setup file named “New Setup”, the new setup
file is a copy of the 'new setup' file. The user can create this 'New Setup' file by first copying
an existing setup file, renaming the file to 'New Setup' then copying the file to the Default
folder. The intention is to provide a user specified starting point for all setup files instead of
the factory default.
To create a new mold setup file, do the following:
1. On the Mold Setup screen, touch the desired mold folder.
2. Touch the New Mold Setup button. A dialog box will open.
3. Enter the name of the new mold setup.
4. Touch the Accept button.
6.1.3 Saving Changes to a Mold Setup File
Once a Mold Setup file has been loaded, any changes made to it can be permanently saved.
To permanently save changes to a Mold Setup file do the following:
1. On the Mold Setup screen, touch the Save Changes button. This will display the Mold
Setup - Save dialog box for confirming the mold and name of the file that the changes
are to be saved to.
2. Touch the Accept button.
All changes have now been permanently saved to the currently loaded Mold Setup File.
6.1.4 Discarding Changes to a Mold Setup File
All changes to a mold setup file are held in the system's data base until they are permanently
saved or discarded. Discarding changes will take the mold setup file back to its state after that
last save was performed.
To discard changes to a Mold Setup file, do the following:
1. On the Mold Setup screen, touch the Discard Changes button. This will display the
Mold Setup - Discard dialog box for confirming the mold and name of the file that the
changes are to be discarded from.
2. Touch the Accept button.
All changes have now been permanently discarded from the currently loaded Mold
Setup File.
6.1.5 Saving the Current Mold Setup File as a New File
Once a Mold Setup file has been loaded, it can be saved as a new file.
To save the currently loaded Mold Setup file as a new file, do the following:
1. On the Mold Setup screen, touch the Save As button. This will display the Mold Setup
- Save As dialog box for confirming the mold and new name of the file.
2. Touch the Accept button.
To Next Page
Loading...
