Controller Function Buttons 17
User Guide v 2.3 — September 2015 Altanium Operator Interface
4.1.3.1 Controller Function Buttons
4.1.3.2 System Status Field
Button Description
Touch the Stop button to switch off the power to all zones, regardless of
system condition.
Touch the Start button to switch on the power to the zones that have a
setpoint displayed.
Touch the Standby button to place the system in standby. If a timer is
active, the time remaining is displayed in the status bar. This button is not
available during ART.
Touch the Boost button to place the system in boost mode. If a timer is
active, the time remaining is displayed in the status bar. This button is not
available during ART.
Button Description
At Temperature indicates the following:
• Flashes when the controller is heating zones up to the setpoint
temperature.
• Solid when all automatic zones are ‘At temperature’.
• Off if the controller is in the ‘Stop’ state.
Company Name is displayed.
To Next Page
Loading...
