Disconnecting the Display Module 185
User Guide v 2.3 — September 2015 Maintenance
2. Facing the front of the controller, locate the four 1/4 inch-20 button head cap screws
that hold the Delta3 interface plate to the mainframe.
3. Remove the four screws using the 5/32 inch hex wrench provided with the controller.
4. Disconnect the interface plate from the mainframe. Place the interface plate on a flat
surface.
5. Facing the bottom of the interface plate, locate the four 1/4 inch-20 button head cap
screws under the interface plate.
IMPORTANT!
A minimum of 2 people are required to perform this procedure.
Figure 15-9 Disconnecting the Delta3 Interface Plate from the Mainframe
1. Button Head Cap Screws, Front
IMPORTANT!
Make sure to support the display module when disconnecting the interface plate.
To Next Page
Loading...
